35
Elite Traveller www.pridemobility.com
VIII. BASIC TROUBLESHOOTING
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and can
no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting
quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below
develops.A beep code will begin with a series of fast beeps directly followed by slower beeps which
indicates the actual code. The beep code is only beeped once. To repeat the beep code, remove the key,
then reinsert it.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel
Scooter has been turned off, then turned back on.
What if all the systems on my Travel Scooter seem to be “dead”?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Travel Scooter.”
Make certain that the battery pack is seated properly.
Be sure the power down timer feature has not been activated. See V. “Operation.”
Check the tiller console fuse located under the battery pack.
BEEP CODE CONDITION SOLUTION
(1)
Battery voltage is too low to operate the
Travel Scooter.
Charge batteries as soon as possible.
(2)
Battery charge is too low. Charge batteries.
(3)
The Travel Scooter's battery voltage is too
high to operate the scooter, or the charger is
still connected to the off-board charger port.
Unplug charger and/or turn key off, then back
on again. If traveling down a slope, reduce
Travel Scooter speed to the minimum setting.
(4)
Current limit time out. Turn the Travel Scooter off for a few minutes,
then turn your Travel Scooter back on.
(5)
The manual freewheel lever is in the (for-
ward) freewheel position
.
Remove the key from the key switch, then push
the manual freewheel lever to the drive (back-
ward) position and restart your Travel Scooter.
(6)
Throttle control lever not at center position
at start up.
Return the throttle control lever to center
position, turn Travel Scooter off then back on.
(7)
Speed pot error. Contact your authorized Pride Provider for
assistance.
(8)
Motor volts error. Contact your authorized Pride Provider for
assistance.
(9)
Other internal errors. Contact your authorized Pride Provider for
assistance.
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals